The ‘Cisco router’ Archives
Posted September 18, 2003 by

Enable and password protect telnet logins to Cisco routers

The ability to telnet to a Cisco router makes administration easier. This simple configuration enables telnet logins to the router and protects them with a password.

Category Cisco router

Posted September 18, 2003 by

Change the Enable Password on a Cisco Router

The enable password is similar to the superuser or Administrator password and protects your Cisco router. Only after authenticating with this password can you make changes to your device.

Category Cisco router

Posted September 18, 2003 by

Configure a default route on a Cisco router

The default route is the IP address of the next hop when no other routes are known.

Category Cisco router

Posted September 18, 2003 by

Show the IP routing table in a Cisco router

Command to display the IP routine table of a Cisco router.

Category Cisco router

Posted September 18, 2003 by

Show a summary of a Cisco router interfaces

This quick command shows the up or down state and ip address of all interfaces on the Cisco router.

Category Cisco router

Posted September 18, 2003 by

Add a Static Route to a Cisco Router

A static route adds an entry to the routing table for a specific destination IP address or subnet.

Category Cisco router